When the machine is working and mixing, the material in the machine is subjected to the action of two rotors in opposite directions to perform a compound motion. The paddle drives the material to rotate counterclockwise along the inner wall of the machine slot, and on the one hand drives the material to turn left and right, and the two rotors overlap in the shape of the cross. Weightless area, in this area, regardless of the shape, size and density of the material, the material can be floated in an instant weightless state, which enables the material to form an all-round continuous cycle flipping in the machine tank, and cut each other staggered, so as to achieve Quick and gentle blending for an even effect.

      1. The machine is a horizontal cylinder, with a unique structure of inner and outer two-layer spiral belts, stable operation, reliable quality, low noise, long service life, convenient installation and maintenance, and a variety of agitator structures, a wide range of multi-functional mixing equipment.

       2. The mixing speed is fast, the mixing uniformity is high, especially the viscosity. The scraper can be installed on the spiral belt, which is more suitable for thick and paste mixing.

      3. Under the mixing requirements of different materials (special materials must be cleaned after each mixing), different spiral belt structures are used, and the jacket type can be heated and dried.

      4. Special atomized liquid is equipped with special nozzle.

      5. The horizontal body can also be equipped with a movable door for the user to clean.

      1. This Ji should be placed in a dry environment without any corrosive medium.

      2. After use, be sure to clean the inside of the cylinder and the stirring blade with clean water and dry it. (If you don't use it for a long time, you can use anti-rust oil on the inside and on the surface of the blade)

      3. Always pay attention to whether the fasteners are loose after use, and tighten them in time.

      4. When feeding, it is strictly forbidden to sandwich iron nails, iron wires and other hard objects in the cement and sand to avoid damage to the machine.

      5. After the gear box has been used for a period of time, check the level of its lubricating oil, and add it to the observation hole in time to see the oil level, and the oil quality is 30# mechanical oil

      6. In case of repair and dumping, the oil in the oil pan must be drained first, and the oil should be changed once a quarter.